OK, I had a router with WEP protection and all was well.

Then I got an upgraded router and had it on WEP and all was well.

 There was one item (a wireless camera) that could not use WPA, that is why I was on WEP.  Well last weekend I got a firmare update for that camera that works with WPA, so I switched everything over...

 PCTV worked well on my LAN.  Didn't get a chance to check remotely until today.  It says "does not respond, make sure it has power and is connected".

My camera works well from remote, so does remote into my desktop.

 When I access my router remotely, it lists the PCTV as connected using my static IP of 192.168.1.150,  just like it should

 Please help me figure out why I can't get in remotely...I will go home tonight and reboot it, but I can't imagine it is that since it is connected to my router...could it be WPA, even though it is connected to my router and I can stream on my LAN using wireless?

Thanks in adavance.

OK, I have tried everything.  LAN connections working well...cannot connect to remote even from home. says it's disconnected.

I wonder if the server is down?   Anyone know how to check? 

Update:  OK, now I think it is the server.  I reset the PCTV and re-ran the wizard, all went smoothly until I got to remote setup, and it just hung on that step, couldn't connect.  I can run PCTV throughout my LAN both wireless and wired, I can surf the net both wireless and wired, but I cannot connect to the remote feed either through my LAN or from work.  I would think that if the server is down, more people would be complaining though, and I don't hear much.   The only other option is my router, but I don't understand since I can use the LAN functions without problems....please help.

Update:

I did a hard reboot and renamed my device different name, and it worked....???!!!

Now I have another problem with it losing settings.

It worked so well for so long, now all these troubles...