Studio - Capture

Re: Pinnacle does not recognise Firewire

Marc P. — Fri, 26 Jun 2009 09:54:54 GMT

Keep us posted when you get the time.

Re: Pinnacle does not recognise Firewire

PCLEUSB2_fan — Thu, 25 Jun 2009 22:09:15 GMT

Also, if your camcorder is properly detected in Windows, a separate device manager entry will be listed. Look for Imaging devices and it should say your camera model or DV camcorder under it.

Re: Pinnacle does not recognise Firewire

jjn — Thu, 25 Jun 2009 11:00:08 GMT

What do you get if you look in the Device Manage?See below...

Is this firewire that is part of your computer, or do you have a Pinnacle capture device with a firewire port?

Pinnacle does not recognise Firewire

Jason V — Thu, 25 Jun 2009 10:31:19 GMT

Hello,

I had firewire working but I had to reinstall studio as it was very jittery. I have version 9.0 which I then add the 9.3.4 patch. When I connect firewire I have to manually open studio and then select capture. I get a message "If you are trying to capture from a DV or digital 8 Camcorder. 1. make sure thecamcorder isturned on (which it is), is in vtr/VCR/play mode (which it is) and is connected to the 1394 port on the computer (which it is). I amusing a 4 pin to 4 pin and it did work fine until I did the re-install, so the cable is ok. Can I check device manager or something to see if the 1394 is recognised? I am not getting the 'bing bong' sound that I used to get either. Can I install a driver or something?any ideas?