I've learned my remote from my samsung dcb 9401r digital cable receiver.

It works in pctv to go player but NOT in vista's media center.

What can I do or buy to make media center switch channels on my samsung dcb 9401r to? So I can record programmed shows..

Thanks in advance!

The fine print says you need this:

 Pinnacle Remote Kit for Windows Media Center

 

My status as of 5 minutes ago:

US Postal Service:

 Label/Receipt Number: 9xxx 1xxx 7xxx 7xxx 8xxx 9x

 Detailed Results:
 
 Processed, August 20, 2008, 10:42 pm, RICHMOND, CA 94804

 Shipment Accepted; August 20, 2008, 7:56 pm, RICHMOND, CA 94804

 Electronic Shipping Info Received, August 16, 2008

 Picked Up by Shipping Partner, August 15, 2008, 1:08 am, EDEN PRAIRIE, MN 55344

Still waiting.

It arrived today in the mail and was set up in 10 minutes. Works like it should. Now I can see TV in windows media center again. Thank God it was still recording my TV shows without the remote. I had the TV shows set up to record with Hauppage PVR-150 and never removed that setting. Windows Media Center does not care where the signal comes from so when I installed the PCTV To Go HD and removed the PVR-150 it automatically went to the PCTV to Go to record.

Here is the kicker about this:

Before I got the remote from Pinnacle I still had my Media Center set up to record my shows using Hauppage PVR-150 in Vista Media Center.

Well I removed the TV cable going to the Hauppage and just installed PCTV To Go Wireless all the way up and to "Can not locate IR Transmitter/Receiver".

Well It still recorded channel 72 like it was suppose to Friday Night at 9pm.

I guess Media Center did not care where it got the TV signal from.

I never checked out this setup any further because I finally got my Pinnacle Remote.